Knowledge

Methods for Eliminating Static Electricity Caused by Film Slitter Winding

Jun 11, 2025 Leave a message

As film slitter speeds increase, the intense friction between the insulating polymer film material and the rubber and metal rollers during the slitting process generates significant static electricity. This can easily attract dust from the material, affecting the quality of the film roll, particularly on printed films.

The mutual attraction and repulsion of static electricity can cause relative displacement between film layers, leading to a series of winding problems such as slippage, slitting offset, and tension variations. Furthermore, severe friction can generate extremely high potentials exceeding 100,000 volts, which can cause air discharges and directly lead to fires or cause electric shock and injury to operators. Static electricity caused by film slitter winding is extremely detrimental to both production safety and efficiency.

Currently, static elimination products are commonly used to address this issue at the winding site. There are two common methods for eliminating static electricity: active and passive. Passive methods include static elimination ropes, static brushes, and static copper wire. They are a cost-effective solution, especially when active static elimination equipment is unavailable. The typical method involves placing conductive fibers close to the material surface to create an electric field and ionize the surrounding air, neutralizing the target's static charge. Active static elimination typically uses ion rods to generate a large number of positive and negative charges to neutralize static electricity on the material surface. It should be noted that for center winding, the static rod is typically mounted above or below the winding shaft, while for surface winding, it is typically mounted on the side where the film exits the pressure roller. Duplex winding requires installation in a location that can handle two different winding positions.

Send Inquiry